Greater London · Replace an old drive

Replacing tarmac or concrete with block paving in Dagenham

Our replacing tarmac or concrete with block paving service covers Dagenham and nearby Becontree, from first measurements to the final sweep of kiln-dried sand. You get a written, itemised quote before anything is booked.

  • Postcodes RM10, RM12, RM13
  • £115–£215 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

What to know before a replacement block drive in Dagenham

Dagenham has a big mix of housing, from older terraces near the centre to newer estates further out, so no two drives here start from the same ground.

Front gardens in much of London are short, so parking depth and the dropped kerb usually decide whether a drive is possible.

How much does a replacement block drive cost in Dagenham?

Guide price in Dagenham£115–£215 per m²Including VAT at 20%

For Dagenham, our guide is £115–£215 per m² including VAT, so a 45 m² replacement drive is likely to be £5,150–£9,700. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£115–£215 per m²
Breaking out an old surface£12–£50 per m²
Edging or kerb, bedded and haunched£25–£60 per metre
Typical channel drain run£420–£1,200
Dropped kerb (vehicle crossover) construction£1,200–£3,600

Guide figures for London, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our replace an old drive service

Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.

  • Drainage added where the old drive sent water to the house or road
  • Break-out of the old surface with waste removal and skip or grab lorry
  • New edging, sub-base where needed, and the block drive
  • Assessment of the old base: keep, top up or replace
  • Levels set below the damp-proof course with falls away from the house

What we check on a Dagenham survey

  • Edges against lawns, beds, walls and neighbours
  • Trees and roots near the drive
  • Ground conditions under the old surface and how deep the sub-base must be
  • Where rain will go: falls, lawn, border, channel or soakaway
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)

Planning and kerb rules in Dagenham

Dagenham is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

What happens next

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

What you can expect from us

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Itemised quotes

Break-out, waste, edging, drainage and covers are separate lines you can see.

One point of contact

You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.

Replace an old drive in Dagenham: questions

Can you match the blocks to my house in Dagenham?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

How much does a replacement block drive cost in Dagenham?

Our guide for Dagenham is £115–£215 per m² including VAT, so a 45 m² replacement drive is usually about £5,150–£9,700. Your fixed price follows the survey.

Is the survey in Dagenham free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

How long does a replacement block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Replace an old drive near Dagenham

Nearby towns we cover for replace an old drive, and replace an old drive across Greater London:

Other block paving services in Dagenham

Or see all block paving services in Dagenham.

Next step

Get a guide price in two minutes

Want a number before a visit? Try the guide price tool, then book a survey to fix it.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote