Replacing tarmac or concrete with block paving in Cricklewood: the local picture
Cricklewood has a big mix of housing, from older terraces near the centre to newer estates further out, so no two drives here start from the same ground.
Many London streets have controlled parking and narrow frontages, so we measure the car space and the crossover before anything else.
How much does a replacement block drive cost in Cricklewood?
In London, a replacement block drive usually costs £115–£215 per m² including VAT. For a 45 m² replacement drive, that is roughly £5,150–£9,700. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £115–£215 per m² |
| Breaking out an old surface | £12–£50 per m² |
| Edging or kerb, bedded and haunched | £25–£60 per metre |
| Typical channel drain run | £420–£1,200 |
| Dropped kerb (vehicle crossover) construction | £1,200–£3,600 |
Guide figures for London, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Break-out of the old surface with waste removal and skip or grab lorry
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
- Assessment of the old base: keep, top up or replace
- Levels set below the damp-proof course with falls away from the house
Before we price your replacement block drive
- Steps, thresholds and door heights
- Existing manhole and inspection covers, and whether to recess them
- Where an electric vehicle charger cable might run
- Edges against lawns, beds, walls and neighbours
- Trees and roots near the drive
Rules for front drives in Cricklewood
Cricklewood is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
How we work
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Replace an old drive in Cricklewood: questions
How much does a replacement block drive cost in Cricklewood?
Our guide for Cricklewood is £115–£215 per m² including VAT, so a 45 m² replacement drive is usually about £5,150–£9,700. Your fixed price follows the survey.
Do I need planning permission for a replacement block drive in Cricklewood?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Can you match the blocks to my house in Cricklewood?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
Replace an old drive near Cricklewood
Nearby towns we cover for replace an old drive, and replace an old drive across Greater London:
- Replace an old drive in Willesden
- Replace an old drive in Finchley
- Replace an old drive in Shepherds Bush
- Replace an old drive in Brent
- Replace an old drive in Holloway
- Replace an old drive in Acton
