How much does a replacement block drive cost in Derbyshire?
For Derbyshire, our guide is £95–£180 per m² including VAT, so a 45 m² replacement drive is likely to be £4,300–£8,100. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the East Midlands, checked 9 November 2026.
Towns we cover in Derbyshire
Choose a town for local prices and details for replace an old drive:
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
Block drives laid twenty or thirty years ago are often ready for re-laying rather than replacing, because sound blocks outlast a weak base.
- Break-out of the old surface with waste removal and skip or grab lorry
- New edging, sub-base where needed, and the block drive
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- Levels set below the damp-proof course with falls away from the house
What the survey covers
- Ground conditions under the old surface and how deep the sub-base must be
- Trees and roots near the drive
- Block range, thickness, colour and pattern to suit the house
- Where rain will go: falls, lawn, border, channel or soakaway
- Whether front-garden planning rules apply
Rules for front drives in Derbyshire
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
Replace an old drive in Derbyshire: questions
Do I need planning permission for a replacement block drive in Derbyshire?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Is the survey in Derbyshire free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
How much does a replacement block drive cost in Derbyshire?
Our guide for Derbyshire is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Can you match the blocks to my house in Derbyshire?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
