County Antrim · Permeable paving

Permeable block paving in Larne

Planning a permeable block drive in Larne? Start with a free survey: we check levels against the damp-proof course, the ground, the drainage and the kerb before pricing anything.

  • Postcodes BT40
  • £100–£160 per m² inc VAT
  • Free survey for new paving
Grey permeable block paving with grit-filled joints soaking up rain on a driveway

Permeable block paving in Larne: the local picture

Around Larne, plots are often larger and drives longer, so edging, falls and the route the water takes need planning.

Wet winters in Northern Ireland make falls, edge restraints and full joints especially important.

How much does a permeable block drive cost in Larne?

Guide price in Larne£100–£160 per m²Including VAT at 20%

Guide price in Larne: £100–£160 per m² including VAT, which puts a 50 m² drive at about £5,000–£8,100. These are Northern Ireland guide figures; the survey confirms the real price before you commit.

ItemGuide price inc VAT
Permeable block paving driveway£100–£160 per m²
Breaking out an old surface£9.50–£40 per m²
Edging or kerb, bedded and haunched£19–£50 per metre
Typical channel drain run£330–£950
Dropped kerb (vehicle crossover) construction£950–£2,850

Guide figures for Northern Ireland, checked 9 November 2026. See all prices or use the guide price tool.

What is included?

It is the straightforward way to pave a front garden without sending rain into the road, which matters because in England a non-permeable front surface over 5 m² that does not drain to a permeable area within the property needs planning permission, and in Wales any new front surface must be permeable or drain within the property. The build is different from a standard drive from the ground up, so it has to be designed as permeable rather than just using different blocks.

  • Ground check: how well the soil drains and how high the water table sits
  • Deeper dig-out for the open-graded sub-base
  • Edge restraints and any overflow or outlet the design needs
  • Open-graded crushed stone (no fines) laid and compacted in layers
  • Geotextile layer where the design needs one

What we check on a Larne survey

  • Steps, thresholds and door heights
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Access for a mini-digger, skip or grab lorry
  • Ground conditions under the old surface and how deep the sub-base must be
  • Trees and roots near the drive

Planning and kerb rules in Larne

Larne is in Northern Ireland, so these rules apply:

In Northern Ireland, a hard surface between the front of the house and the road that covers or replaces more than 5 m² must be porous or permeable, or drain to a permeable area within the property, to be permitted development.

Hard surfaces within the grounds of a listed building need listed building consent. Planning is handled by your district council, so check with its planning office if you are unsure.

Dropped kerbs in Northern Ireland are approved by DfI Roads (the Department for Infrastructure), not the council; check planning separately with the council.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

What happens next

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

Why choose Block Paving Contractors

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

Permeable paving in Larne: questions

Do I need planning permission for a permeable block drive in Larne?

In Northern Ireland, front paving over 5 m² must be porous or drain within your boundary to be permitted development. Ask us on the survey if you are unsure.

How long does a permeable block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Is the survey in Larne free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

Can you match the blocks to my house in Larne?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

Permeable paving near Larne

Nearby towns we cover for permeable paving, and permeable paving across County Antrim:

Other block paving services in Larne

Or see all block paving services in Larne.

Next step

Get a guide price in two minutes

Tell us what you have in mind for Larne, and we will put a written price together.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote