How much does a driveway extension cost in Derbyshire?
For Derbyshire, our guide is £90–£150 per m² including VAT, so a 15 m² extension is likely to be £1,550–£2,600. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Driveway extension in block paving | £90–£150 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the East Midlands, checked 9 November 2026.
Towns we cover in Derbyshire
Choose a town for local prices and details for drive extensions:
What does a driveway extension involve?
A driveway extension adds paving to an existing drive, usually to fit a second car by taking in part of the front lawn, or to lengthen a drive towards the house or garage. The new section is built on its own sub-base and tied into the old paving so the two act as one surface.
Clay and mudstone ground is common in the East Midlands, so we allow for a deeper sub-base where the survey shows soft ground.
- Dig-out and sub-base for the new area
- Check of the existing drive: block range, thickness, levels and condition
- Joint sand, compaction and a clean-down of the old section
- New edging, kerbs or a low retaining edge where the lawn is cut back
- Old edge restraint taken out and the new paving toothed into the old pattern
What the survey covers
- Block range, thickness, colour and pattern to suit the house
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Ground conditions under the old surface and how deep the sub-base must be
- Edges against lawns, beds, walls and neighbours
- Whether front-garden planning rules apply
Rules for front drives in Derbyshire
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
Drive extensions in Derbyshire: questions
Do you cover Derby, Chesterfield and Long Eaton?
Yes. We cover all of Derbyshire, including Derby, Chesterfield and Long Eaton.
How long does a driveway extension take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Do I need planning permission for a driveway extension in Derbyshire?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Can you match the blocks to my house in Derbyshire?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
