Forth Valley · Block paved driveways

Block paving driveways in Alloa

Our block paving driveways service covers Alloa and nearby Stirling, from first measurements to the final sweep of kiln-dried sand. You get a written, itemised quote before anything is booked.

  • Postcodes FK10, FK12, FK13
  • £85–£140 per m² inc VAT
  • Free survey for new paving
Silver-grey herringbone block paved driveway with a charcoal border in front of a detached house

Block paving driveways in Alloa: the local picture

In and around Alloa, village-style frontages sit alongside newer cul-de-sacs, so the right block often depends on the age of the house.

Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.

In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.

How much does a block paved driveway cost in Alloa?

Guide price in Alloa£85–£140 per m²Including VAT at 20%

Expect block paved driveways in Alloa to come in at around £85–£140 per m², including VAT at 20%. As an example, a 50 m² double drive usually comes to between £4,250 and £7,000.

ItemGuide price inc VAT
Concrete block driveway, new sub-base£85–£140 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.

What is included?

A block paved driveway is a surface of small concrete or clay blocks laid tightly on a bed of sharp sand, held in by a fixed edge and locked together with kiln-dried jointing sand. Laid on a properly dug and compacted sub-base, it carries cars for decades, and a single damaged block can be lifted and replaced without breaking the surface.

  • Sharp-sand laying course screeded to falls
  • Survey, measurements and a written, itemised quote
  • Crushed-stone sub-base laid in layers and compacted
  • Kiln-dried sand brushed in and the surface vibrated with a plate compactor
  • Edge restraints or kerbs bedded and haunched in concrete

What the survey covers

  • The kerb: is it already dropped, and is it wide enough?
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Access for a mini-digger, skip or grab lorry
  • Trees and roots near the drive
  • Steps, thresholds and door heights

Planning and kerb rules in Alloa

Alloa is in Scotland, so these rules apply:

In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.

Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.

A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

What happens next

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

What you can expect from us

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Block paved driveways in Alloa: questions

Can you match the blocks to my house in Alloa?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

How much does a block paved driveway cost in Alloa?

Our guide for Alloa is £85–£140 per m² including VAT, so a 50 m² double drive is usually about £4,250–£7,000. Your fixed price follows the survey.

How long does a block paved driveway take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Is the survey in Alloa free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

Block paved driveways near Alloa

Nearby towns we cover for block paved driveways, and block paved driveways across Forth Valley:

Other block paving services in Alloa

Or see all block paving services in Alloa.

Next step

Get a guide price in two minutes

Want a number before a visit? Try the guide price tool, then book a survey to fix it.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote