Block paving driveways in Fraserburgh: the local picture
Fraserburgh is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a block paved driveway cost in Fraserburgh?
Guide price in Fraserburgh: £85–£140 per m² including VAT, which puts a 50 m² double drive at about £4,250–£7,000. These are Scotland guide figures; the survey confirms the real price before you commit.
| Item | Guide price inc VAT |
|---|---|
| Concrete block driveway, new sub-base | £85–£140 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our block paved driveways service
A block paved driveway is a surface of small concrete or clay blocks laid tightly on a bed of sharp sand, held in by a fixed edge and locked together with kiln-dried jointing sand. Laid on a properly dug and compacted sub-base, it carries cars for decades, and a single damaged block can be lifted and replaced without breaking the surface.
- Blocks laid in your chosen pattern, with a contrasting border if wanted
- Sharp-sand laying course screeded to falls
- Survey, measurements and a written, itemised quote
- Crushed-stone sub-base laid in layers and compacted
- Kiln-dried sand brushed in and the surface vibrated with a plate compactor
Before we price your block paved driveway
- Ground conditions under the old surface and how deep the sub-base must be
- Access for a mini-digger, skip or grab lorry
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Whether front-garden planning rules apply
- Trees and roots near the drive
Planning and kerb rules in Fraserburgh
Fraserburgh is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Block paved driveways in Fraserburgh: questions
Do I need planning permission for a block paved driveway in Fraserburgh?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
Can you match the blocks to my house in Fraserburgh?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
How much does a block paved driveway cost in Fraserburgh?
Our guide for Fraserburgh is £85–£140 per m² including VAT, so a 50 m² double drive is usually about £4,250–£7,000. Your fixed price follows the survey.
How long does a block paved driveway take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Block paved driveways near Fraserburgh
Nearby towns we cover for block paved driveways, and block paved driveways across Aberdeen and Aberdeenshire:
